ARP Head Stud Kit for 1993-98 Supra - L19 Exotic

Cheap? Not exactly. The best? No doubt! That is why we stock them on our shelf! You do not have to wait, we have these ready to go unlike our competitors!

Until now the only way to hold your head down when you are trying to make big power with the 2JZ has been to bore out your head and install 1/2" special order ARP head studs. We now have a quicker and easier solution for you!

L19 material offered by ARP is the most expensive and strongest material offered in a stud. MVP has ordered STOCK size ARP studs in the L19 material! These will provide over 1000psi MORE clamping force over standard 1/2" studs and they are a direct swap! If you already have a built motor you could even swap these out one by one and not have to redo the top part of the motor!

This material is special order and VERY expensive. When you consider doing 1/2" studs you have to machine the head, machine the block, redo the head gasket, buy 1/2" studs, washers, nuts, and they are a pain to install. And you also have to transport an entire engine somewhere to do it. This solution is much more cost effective and feasibly work better than 1/2" studs while saving you time and work.

There are a few high HP Supras already running these studs with no issues so they are proven to work. ARP has also done all the calculations and assure us that these studs do offer MORE clamping force than the standard 1/2" studs.

These studs make building a very high horsepower engine significantly easier. You can build a new motor and put these in to start or if you already have a built motor on standard ARP 7/16 studs you can pull them out one by one and swap them in for these.